Conrad IV Joseph, PhD

Salvage harvesting is common in the US South following natural disasters such as tornadoes and hurricanes; nevertheless, few studies have evaluated the productivity and costs of these harvests because of their geographic dispersion and the short interval between natural disasters and salvage harvesting. An Enhanced Fujita Scale 3 (EF3) tornado with winds in excess of 250 km per hour struck Aiken County, South Carolina in April of 2020, uprooting trees and severing other stems above breast height. The goal of this study was to estimate the productivity and cost of salvage harvesting in loblolly pine (Pinus taeda L.) stands following severe tornado damage. Salvage harvests were conducted with a rubber-tired drive-to-tree feller-buncher, grapple skidder, tracked loader, and chipper. All stems were chipped and used to produce energy; no roundwood was produced from the harvests. Elemental time-and-motion studies were conducted in three pulpwood-sized stands (<30 cm large-end diameter) and three sawtimber-sized stands (≥30 cm large-end diameter). Hourly harvesting costs were estimated using the machine rate method and per-ton costs were estimated using a modified version of the Auburn Harvesting Analyzer. Skidding productivity was low in each harvest unit, but especially so in the three pulpwood-sized stands because of stem breakage and low weight per stem. Harvesting costs averaged $29.78 and $19.97 (USD) per tonne (onboard truck) in the pulpwood- and sawtimber-sized stands, respectively. High salvage harvesting costs mean that landowners can expect significantly reduced stumpage prices from these harvests; nonetheless, landowners do benefit from reduced reforestation costs. Harvesting promptly after a tornado can reduce harvesting costs and increase timber value recovery.

Log truck gross vehicle weight (GVW) limits in the US state of Georgia are among the lowest of any timber-producing state in the US and are far below GVW limits in countries such as Australia, Canada, Finland, and Sweden. In the state of Georgia, log trucks travel on county and state roads between harvest sites and forest industry mills. Most county roads were not constructed to support heavy trucks and so log trucks may damage these roads, even at the low GVW limits allowed in Georgia. Local governments sometimes enact timber harvesting ordinances to constrain timber transportation and often oppose efforts to increase GVW limits. The purpose of this study was to document local transportation officials’ perceptions of timber harvesting and transportation and to measure their support or opposition to alternative log truck weights and configurations. A telephone survey of county transportation superintendents or their equivalent was conducted in Georgia during the summer of 2020. Forty-three county officials responded to the survey, yielding a response rate of 43%. Ninety-eight percent of respondents reported that timber harvesting was important to their local economy, and 86% agreed that local governments were cooperative with log truck owners. County officials were concerned about damage from overweight log trucks and mud on public roads. The average preferred GVW and tandem axle weight limits were approximately 10% lower than the existing limits. County officials opposed six- and seven-axle 45,359 kg (100,000 lbs) GVW configurations but did support allowing log trucks to operate on interstate highways at current state weight limits. Findings suggest that logging businesses and mills should focus on improving compliance with weight laws, improving the condition of log trucks, and maintaining or improving relationships with the public and local government officials.

The aim of the study was to provide a comprehensive overview of global long-distance road transportation of industrial roundwood. The study focused on the maximum gross vehicle weight (GVW) limits allowed with different timber truck configurations, typical payloads in timber trucking, the road transportation share of the total industrial roundwood long-distance transportation volume, and the average long-distance transportation distances and costs of industrial roundwood. The study was carried out as a questionnaire survey. The questionnaire was sent to timber transportation logistics experts and research scientists in the 30 countries with the largest industrial roundwood removals in Europe, as well as selected major forestry countries in the world (Argentina, Australia, Brazil, Canada, Chile, China, Japan, New Zealand, South Africa, Türkiye, the United States of America and Uruguay) in February 2022, and closed in May 2022. A total of 31 countries took part in the survey. The survey illustrated that timber trucking was the main long-distance transportation method of industrial roundwood in almost every country surveyed. Road transportation averaged 89% of the total industrial roundwood long-distance transportation volume. Timber truck configurations of 4 to 9 axles with GVW limits of around 30 tonnes to over 70 tonnes were most commonly used. The results indicated that higher GVW limits allowed significantly higher payloads in timber trucking, with the lowest payloads at less than 25 tonnes, and the highest payloads more than 45 tonnes. The average road transportation distance with industrial roundwood was 128 km, and the average long-distance transportation cost in timber trucking was €11.1 per tonne of timber transported. In the entire survey material, there was a direct relationship between transportation distance and transportation costs and an inverse relationship between maximum GVW limits and transportation costs. Consequently, in order to reduce transportation costs, it is essential to maximise payloads (within legal limits) and minimise haul distances. Several measures to increase cost- and energy-efficiency, and to reduce greenhouse gas emissions in road transportation logistics, are discussed in the paper. On the basis of the survey, it is recommended that up-to-date statistical data and novel research studies on the long-distance transportation of industrial roundwood be conducted in some countries in the future.